Posted by jdemaris on October 19, 2010 at 10:36:08 from (67.142.130.20):
The subject of walking 6/12 pitch metal roofs was brought up a few posts down from this one. Here are two I just did and no way could any of us walk the 6"/12" pitch steel roof safely - even with the best and softest sneakers and warm/dry conditions.
This one is in the Adirondacks. 6/12 pitch (6" vertical rise/drop to the horizontal foot). I had to use a rope tied to my belt to help me keep my "footing." Later, when I went back to install solar panels, me and a friend (prof. roofer) tried to walk it and could not - without rope. We finally laid a ladder on the roof and tied it up there. It gave us steps to walk on while installing and wiring the solar panels.
This one is an 1820 farm house that had some huge dips in the old roof. Not because the rafters were bad; more because the foundation sank near a foot over 100 years ago. So, I had to shim much of it up to get fairly straight lines - to put the new steel roofing on. House was originally wood shingled, then soldered-tin, then asphalt, and now painted steel. Note the pitch is exactly 5.5/12. I could walk it safely when the asphalt was there (if warm and dry). With the steel? I could walk if warm and dry, but not safely. I'd slide now and then. When cold or wet - forget it. I finished the job with a rope tied to me - which I used many times to keep me from sliding off. This house has five chimneys which aren't exactly fun to get flashed properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
