We Do alotta Steel Roofing And I usually instal the Screw in The (lump) ridge , after educational Discussion with those paying the Bill .FLATS will WORK fine as long as the wood does not weaken (HEAT TOASTER DRY BURNUP ),,. I have a 1/12(FLAT virtually ) pitch roof on my machine shed 38x55 lean to off the shop,,Built in 1987 , Using 1x6-12ruf cut cull lumber on 2ft centers over 32inch center Joists rafters , in order to run a ONGOING TEST , We fastened in the Flats , besides I knew I would Have to shovel snow off the Roof ,,GREAT results , Except for perhaps 5 leaks that have developed over the years , All in a BAD SECTION OF CULL Lumber (Knots,Split ,Crack ect. ) ,, One LEAK to ME even after 10 yrs,condemns the Practice of Screwing in the FLATS as UNrelieable, I label such Practices as a Unskilled Lazy Mans Copout
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
