Many Code jurosdictions require a complete tearoff before steel is applied on required nominal 2X perlins no more than 2'OC, with min of 1.5" screws., but they allow a second layer of shingles.Go figure! When I was GCing I got shut down on a garage roof job. Had to remove the new steel and perlins,, we had in place strip the roof and start over. Was just glad it was small and that is what I was relating to in the previous post about the van load of parasites. If you are applying steel over shingles, make sure code enforcment agrees to let you!! Don't try to argue with code enforcement you will loose. In this same town a wealthy Albany NY lawyer built a lavish summer camp on an island in a small lake within the township He pushed the envelope beyond what the code enforcment oficer told him he could do. The town took him to court. The new "high priced camp" was demoed last winter while the ice was strong enough to support the demolition equipment and carry the debris back to shore.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
