|
Tractor Talk Discussion Board |
international 444, 3 pt hydraulics,not working??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by maplehillfrm,pat on June 08, 2003 at 09:09:49 from (216.238.59.99):
hello all, I usually hang on the ford board, does that make me bad,hahaha, anyway, I just bought a int 444 serial 07928, engine runs good, I guess it had a FEL loader on it as it has remote hydraulics in the front as well as the rear. overall a good running tractor, I tried the 3 pt and it does nothing,, I dont feel any "tension either in the quadrant" as this is a new tractor to me, could they have had to tap into the 3 pt hitch hydro to make the FEL work?? or will I maybe have to take the cover off and look at the pump, any info would be appreciated. Pat
Follow Ups:
- Re: international 444, 3 pt hydraulics,not working Alton 20:16:09 06/09/03
(0)
- Re: international 444, 3 pt hydraulics,not working Ben in KY 19:11:38 06/09/03
(0)
- Re: international 444, 3 pt hydraulics,not working pat 08:33:55 06/09/03
(0)
- Re: international 444, 3 pt hydraulics,not working Bob 07:18:02 06/09/03
(1)
- Re: international 444, 3 pt hydraulics,not working Ben in KY 10:09:07 06/08/03
(3)
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
