Tractor Talk Discussion Board |
Re: Re: Re: Re: international 444, 3 pt hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dana on June 09, 2003 at 07:03:28 from (162.114.211.143):
In Reply to: Re: Re: Re: international 444, 3 pt hydraulics,not posted by maplehilfrm,pat on June 08, 2003 at 20:04:21:
I have a IH 364. When I first got it the lift didn't want to go down. As soon as the engine was started the lift would raise unless there was a implement attached. Even then it would raise up when you opened the throttle a bit. Made it impossible to plow or bush hog. The previous owner had added a remote outlet & control lever that was mounted on the fender connected by hoses to the housing under the seat. The dealer had a 'block' that mounted where the two hoses came out of the housing that evidently allowed the fluid to flow from one area to the next allowing the lift to work properly. After removing the remote outlet and installing the block I've had no further problems. Perhaps a similar problem such as rerouted hydraulic hoses for the loader are effecting your lift. Just a thought.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|