|
Tractor Talk Discussion Board |
Re: Need Help with Electrical ASAP!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greg D on February 22, 2003 at 05:27:15 from (209.240.198.61):
In Reply to: Need Help with Electrical ASAP!!! posted by Farmer_sean on February 21, 2003 at 16:55:52:
Only if you promise not to send your "gold" my way will I give my $.02 worth.
If you have as you say a loose connection, it more than likely is your problem. Make sure ALL cnnections are clean and tight. Positive as well as ground connections starting at the battery,starter, alternator/generator and finally the ground to the frame. If it still does as you describe. Connect your multi meter to the starter power terminal and see what the voltage is when you attempt to start it? Does it have system voltage there or does it drop to near zero? Could be a bad cable end. Could be a bed solenoid.
Hope any of this helps before you are buried in white stuff!!!!!!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
