Posted by Jake Adams on June 07, 2014 at 06:47:03 from (74.76.176.199):
hi everyone. a few weeks back i posted a message about my john deere 2010 and how i lost my ability to raise the 3 point arms. we recently got it down of the jack stands and now come to find out we lost our power steering too. There is no hydraulic pressure anywhere. As i said we did clean the suction screen and it does allow oil to pass through it. it also was in the garage all winter because we restored it but everything has been filled with new fresh oil. i don"t think the pump can just go bad sitting in a garage all winter , but its not making any pressure. we can hear it spinning down there and took the seat off to look in at the rock shaft assembly and took out a plug to test pressure. we put oil down it to try to help it get a prime and it will occasionally let out some air bubbles. So what im getting at is we have no pressure. I don"t know if we have to prime it somehow after sitting all winter. If someone knows how to fix this or has any other advice it would be greatly appreciated because we don"t know what else we can do. thanks so much. :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
