Posted by bradley martin on September 11, 2008 at 12:33:34 from (216.209.148.135):
In Reply to: 430 case pto shaft posted by Russt71 on September 11, 2008 at 08:52:31:
I assume that you are talking the PTO stub shaft that you would attach a machine to and not the PTO drive shaft that trnsmits power from the engine to the rear of the tractor and in turn drives the stub shaft. If so, there will be no reason to split the tractor. The entire PTO housing can be removed from the rear of the tractor,and the long drive shaft that runs from the PTO, thru the transmission to the bell housing will come out with the housing. This will allow you to replace the stub shaft. Be very careful when re-inserting the drive shaft as there is a seal that can be easily damaged. You may want to remove the top cover of the rear end so as to guide the long shaft properly. Go to the Case IH web site for parts for an exploded view of the PTO set up. Also, spending $ 20 on a shop manual would be a good investment. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
