|
Tractor Talk Discussion Board |
Re: Converting H to 12 volts
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CRUSADER on January 19, 2007 at 16:11:37 from (70.133.155.167):
In Reply to: Converting H to 12 volts posted by Lincoln on January 19, 2007 at 16:04:11:
Howdy Lincoln, If you decided to convert the H over to 12, it shouldn't be very hard. I have done this before (a long time ago) with several M's and a few H's. Only difference was I used the alternator because it was a lot easier, and fit into the plans for the customers and family a lot better. Don't forget about the starter. You will need to convert it also or it will not last very long once you start using it. Good luck with your project. Jim
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|