Tractor Talk Discussion Board |
Re: Converting H to 12 volts
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on January 19, 2007 at 17:10:02 from (66.173.50.145):
In Reply to: Re: Converting H to 12 volts posted by Bob on January 19, 2007 at 16:15:18:
Bob is correct, there is no issue with the original 6v starters running on 12v. They may last longer due to the fact that they start the tractor more rapidly and often are used less. Many late Farmalls had 12v systems so the most stock parts can be IH. They are for sure Pos ground. If you go Neg ground, a different Neg ground reg is needed. but the gen can be repolarized to Neg ground. Bulbs must be changed in the lights. One other item is the light switch. If it was an early H with a three brush generator, the light switch had 4 positions LHDB These were for the charging system, Make sur that the field wire is not connected to the light switch if using a regulator. Bob M who lerks on this site has very nice diagrams. Good luck JimN
Replies:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|