|
Tractor Talk Discussion Board |
cut out to voltage regulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by bill in Md on June 22, 2006 at 09:22:41 from (64.26.76.21):
i just converted my 52 wd form charging cut to voltage regulator. i polorized it from arm on gene to batt post on VR. before starting enging i am getting a reading of 6.3v on the battery. amp meter before starting showing zero, turn on head lights showing slight discharge. start engine, high idle; i get 6.5 v. at the VR. Amp meter showing slight + charge. turn on headlights amp meter goes back to zero. unhook the batt post on VR and get a reading of 7.5 v. question is, why are my reading so low even with the headlighs on? all wires are new and the battery is good. can someone help an idiot out.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
