|
Tractor Talk Discussion Board |
Re: cut out to voltage regulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on June 22, 2006 at 16:50:05 from (66.244.90.5):
In Reply to: Re: cut out to voltage regulator posted by bill in Md on June 22, 2006 at 13:44:37:
Sounds like the genny is just weak period, maybe from worn brushes or the brush hold down spring assemblies are stuck/corroded and if its an adjustable 3 brush genny, I would be setting it for max charge n try it. Right after cranking the battery ought to be down enough that I would expect full charge for a while at least out of the VR (which dead grounding the Field provides). The only true test (if battery is okay) is what the battery voltage is doing and a good genny n VR ought to raise it from 6.3 volts to at least 6.5 n more indicatimg its charging. Those open circuit genny voltage tests dont tell me much. The only other VR by pass test is to jump the VR"s internal Cutout Relay when shes running by momentarily connecting its BAT and GEN/ARM terminals together to see if she charges and the battery voltage raises then and if so but NOT otherwise, then I suspect the VR"s cutout relay isnt ever closing. Still sounds more like a weak genny for now, check for a 3rd brush and adjust it to max charge n try her with the gennys field dead grounded and the internal cutout relay by passed n if still no charge (IF battery is okay) after cranking and light use which ought to run the battery down a bit, I suspect the genny is weak. You could also remove the belt n try to motor the genny n see how it performs?? John T
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|