Tractor Talk Discussion Board |
Re: cut out to voltage regulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by J Schwiebert on June 22, 2006 at 15:06:30 from (209.143.51.253):
In Reply to: Re: cut out to voltage regulator posted by bill in Md on June 22, 2006 at 13:44:37:
O. K. Let us start in the beginning> Why did you go to a regulator? Second of all did you put an ampmeter in the circuit to see what the generator is producing. Also if you have a bad connection somewhere and the extra resistance is "tricking" the regulator into tell the generator the battery is fully charged. Like I asked and John T commented on also what is the internal condition of the generator? Does this generator have a bushing for a bearing on the back end? I had one once that drove me nuts, the bushing was bad and the armature would not center on the field coils. It did not charge well either. What is the model of the generator? Just for fun, how many Ohms do you have between the light switch and the head lights?
Replies:
Home
| Forums
Today's Featured Article -
Seeing an Old Friend - by Joe Evans. Dad had a concrete contracting business starting in 1960. One of his first pieces of equipment was a Ferguson TO-35 with a Davis loader. Dad replaced the TO-35 with a MF 202 Workbull, essentially an industrialized Ferguson 35 I am told. Dad bought the 202 new in 1962, and I recall quite clearly going to the dealer with him to sign for it.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|