Re: Pulley Troubles - - Help

Posted by Don-Wi on June 21, 2006 at 00:22:48 from (64.12.116.74):

In Reply to: Pulley Troubles - - Help posted by TomTX on June 20, 2006 at 16:32:26:

I'd have the machine shop measure it first, it should be just a standard size and not metric, so I'm guessing either 5/8" or 3/4". If it measures more than .003 over, I'd either pein the inside with a center punch if it's not too big, or bore it out and sleeve it. I've done both at my last job, now I work at another shop that doesn't do any repair work for farmers.

As for the key, put it at 180 from the original and it'll be fine. I've even seen JB weld used in severe conditions and was holding up last I saw.

Donovan from Wisconsin

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]