Re: timing injection pump

Posted by Jerry/MT on February 20, 2006 at 09:55:31 from (67.72.98.45):

In Reply to: timing injection pump posted by Randall Baggett on February 19, 2006 at 16:37:40:

I'm presuming that this is a four stroke diesel engine. If that's the case, it had to be more that just locating a pin through a hole in the crankshaft pulley to get the timing since the cylinder goes through a compression stroke every other revolution of the crank shaft. You must have to also observe the valves on #1 cylinder to make sure they were closed to assure your self they were on the compression stroke. If there is a diesel shop near you, go talk to them about your problem and they might be able to gibve you some good advice. Otherwise you'll have to know the valve timing relative to the injector opening and put a degree wheel on the crankshaft pulley, and find TDC on #1 to determine where to start.
Good Luck.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]