|
Tractor Talk Discussion Board |
OT - Gas Oil leases (long post)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hurryin_Hoosier on March 21, 2006 at 18:22:21 from (4.224.78.232):
I was just contacted by a land agent about signing a gas/oil lease for my property. Apparently they are doing a lot of natural gas speculation in the area. The company they are reps for is Aurora Energy out of Mich. Most of the tracts in the area (100 - 200 acres) that have signed on are farm ground / woods with no residence on the property. Either that or farms with enough acreage they can get out of sight of the house to drill. My little plot w/home is 35 acres with road access only from my driveway. Due to lay of the land, no good access to the backside of the property any other way. Already have a high voltage transmission line cutting across the hayfield on the backside of the property. For the princely sum of $10 they will tie up my oil/gas rights for 5 yrs with their option for another 5 years for slightly more $$. The agreement allows them to drill, put in road access, lay pipe, storage, etc. Cleanup is allowed $500 when they leave. (that should pay for a couple of hours with a dozer and a few loads of gravel or dirt!) My fear is having the mess, odor and disruption ruining the quality of life. Possibly even a well being drilled just past the 200ft distance from the house. The alternative is not sign a lease and maybe they drill on neighboring property and I still have some of the same problems with no compensation whatsoever. If I do sign and they drill down the road and not on me, I will at least get my portion of $$ from what they pull out of the ground because I would be in the "drilling unit". Obviously I can dicker for changes in the lease conditions or feel them out for what they think my property would be used for. But if my ground would not be all that good for a drill site and I start wanting to add lease conditions, why would it be to their advantage to even want me to sign on? Any thoughts or previous experiences anyone would like to share? Sorry for the long post.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
