Tractor Talk Discussion Board |
OT Digging a water well
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by marvin on June 16, 2004 at 15:10:31 from (134.134.136.1):
Other than contracting out to a professional well digger, have any of you been successful in putting in a well to a depth of 50 or 75 foot? What equipment did you use? How long did it take? Here in Washington you can dig your own well and just need to get a permit to do so. You can water up to a half acre without water rights. It was not uncommon in my neighborhood as a kid to hand dig a well down to 25 or 30 foot, but I am not very interested in doing that. I would prepfer to find a cheap economical method to drive a well in.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|