|
Tractor Talk Discussion Board |
Re: Re: Re: Balancing Tires With Golf Balls
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MarkB on November 28, 2003 at 19:47:04 from (64.79.82.17):
In Reply to: Re: Re: Balancing Tires With Golf Balls posted by magic balls on November 28, 2003 at 11:38:16:
Magic, Sorry, but I don't see what a pan of water spinning on a vertical axis has anything to do with a tire spinning on a horizontal axis while running in contact with a road surface. A better analogy would be a barrel half full of water rolling down a hill. Does the water spread itself aroung the perimeter of the barrel? No, it stays on the bottom because gravity makes it stay there. If your washing machine becomes unbalanced because all the clothes are on one side, does if balance itself back out? No, you have to stop it, spread the clothes back around and restart it. I'm aware of the "balance rings" you can buy at any truck stop. J. C. Whitney used to sell them (probably still do), along with all sorts of wonderful products that would double your gas mileage, etc. I'm sure that many people claim they work or they wouldn't sell them. My guess is that they provide enough damping to noticeably reduce vibration, but they sure don't improve the actual balance of the tire. Think about it: If these products actually work, why would any tire dealer spend thousands of dollars on spin balance equipment? This should be a simple test for anyone with access to a spin balancer: Take a mounted tire and deliberately unbalance it. Then dismount it and throw in a golf ball. Check the balance again: Is it better, worse or the same? Anyone got a spin balance machine?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
