Tractor Talk Discussion Board |
6 to 12 volt conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Carl Meadows on April 22, 2003 at 06:31:16 from (170.215.171.184):
I have just been given a 1956 Ford 600 tractor. It was having charging problems and I finally got it fixed. I am interested in converting it to a 12 volt system. A gentleman named Brian has an excellent site with a 22 step procedure, but I have a question and can't contact him through the email link on the site. Anyway, Brian's instruction refer to using a AC-DELCO 10SI alternator and I want to use a brand new AC-DELCO alternator that I have from a 91 Olds. It has the built in regulator, the post marked "BAT" and a three wire conector with the following: Red wire marked "FS", brown wire "PL" and a pink wire with a black stripe, but no designation on the connector. Can anyone tell me if I can use it and how to do the wiring? Thanks in advance, Carl
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|