|
Tractor Talk Discussion Board |
Re: Adding water to fuel
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Jones on July 30, 2002 at 21:29:27 from (67.241.18.248):
In Reply to: Adding water to fuel posted by Sonny Freyholtz on July 30, 2002 at 18:19:22:
Water was added as an ADI (anti dteonation device) the water slowed propegation (spreading ) of the flame front . If the speed of the flame front is slowed,the cylinder pressure can build without the danger of detonation and as the piston goes past TDC the higher effective pressure can do more work on the piston.
This all came about as a solution to poor fuel qualities of that era(low octane). The water wasn't added to cool the cylinder-burning distillate you wanted it hot. In an engine with 8:1 compression and 6.00" stroke and 5.40" bore ( I'm using a Rolls Royce Merlin engine as an example) with the sea level atmospheric pressure at 14.7 psi that would be 270 psi at the top of the compression stroke. On a nice cool day of,say 67 degrees F, the temp jumps to over 752 degrees F at the top of the compression stroke,turning water to steam instantly (flashing) The water in steam form takes up a bit of room too,increasing compression ratio of 8:1 to maybe 9:1.
The water is injected at the right time-AFTER the proper fuel /air mix has been drawn into the cylinder-remember you want the water to flash into steam,NOT take the place of air molecules vital to a proper air fuel ratio. When better fuels were developed (tetraethyl lead) providing more octane ,the water injection became less practical,except in high horsepower warbirds,and then it was only for a short duration-because after you broke the throttle stop safetey wire for Emergency War Power,the engine would need to be rebuilt.
The Germans did develop a complicated Methanol/Water Injection system for their aircraft to boost power.And you can still install a water injection system on your car for high performance
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
