Posted by Goose on December 03, 2013 at 16:52:14 from (70.198.24.87):
Yesterday, the electric door locks on my �05 Dodge Grand Caravan suddenly quit working. It�s important to me that they work, �cause this is my work vehicle and when I�m on the job I normally have a measuring wheel, camera pole, GPS unit, laptop computer, digital camera, backup digital camera, laser measurer, etc. on board and I don�t stray over 10� from the van without hitting the door lock button on the remote.
When I got home, I checked the fuses. Instead of pulling them, I simply hit the little orifices on the fuses with the probe from an electrical tester.
I then posted a thread on this forum asking if anyone had any ideas.
Next, I got on the �Net and lucked out by finding a forum on this specific problem. Apparently it�s a rather common problem, specifically on �05 Caravans. Several posters said they had to pay a Chrysler/Dodge dealer $150 to $200 to reprogram the computer. A couple of other posts said all you needed to do was pull the 20 amp fuse marked IUD, wait 10 seconds, and plug it back in. I tried it and my locks immediately began working again.
I then put 2 and 2 together. All a nefarious dealer would need to do would be to get the vehicle out of sight of the owner, do the bit with the IUD fuse, wait another 20 minutes to make it look good, and charge the unsuspecting customer $200 for �reprogramming the computer�. And they wouldn�t even be lying, �cause I assume the computer reprograms itself while the fuse is pulled.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
