Posted by Yesterday'sRick on November 01, 2011 at 19:05:29 from (209.91.107.179):
1964 JD 4020 was running just fine and had stopped and started it a few times thoughout the day and now when I turn the key on the little red generator (24 V)light comes on full intensity as it should however when I turn the key to start nothing happens, selenoid doesn"t engage or anything. Previously had a connection problem at transmission gear position switch however doesn"t seem to be a problem. I assume it is just a open/close switch but not sure if the permissive is open or closed. Tried disconnecting it with no luck, tried jumpering wire with no luck. Did same for the clutch engagement switch as well also no luck. Can anyone confirm that these are simple open/close switches and if not how can you check them? Also are there any other start permissive switches that anyone is aware of? Thank you in advance for any ideas. P.S. If your response is "get a manual", save your breath.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
