|
Farmall & IHC Tractors Discussion Board |
Farmall 400 engine miss (update)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott (TN) on September 09, 2002 at 18:49:23 from (65.239.223.210):
recap of the problem--tractor lacks power and misses at any speed. Pulled plug wire from each cylinder in turn and when the wire is pulled from # 2 there is no change in the way the engine runs. Update: This tractor is about 4 days from being parted out. Here is what I have done so far: Replaced wires, cap, rotor, points, plugs (AC-87), manifold. Checked compression and it reads 120 on #'s 1,2,3, and 110 on #4. Pulled valve cover and adjusted valve lash to .017 (hot). Ran the engine with the valve cover removed and observed the valves on #2 working. Pulled spark plug on # 2 and watched a nice, pretty blue spark jump the gap. Plug comes out wet when pulled after running the engine. Swapped plugs and wire with other cylinders, problem stays at #2. Measured as closly as I could the valve spring height both valve open and closed, do not remember those at this monment but they were the same as the others. Drained radiator and ran the engine. Problem persists. About the only thing left that I can come up with is the duration of the cam lobes on #2. Any idea of I can measure that without removing the head? Also if anyone can think of something that I may have missed? Thanks in advance for your thoughts
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Gettin My Old Tractor Home - by Clayton Sweeney. My name is Clayton Sweeney. I am from Southern Maryland in a small town called Lothian. I am 20 and my father and I are the proud owner of a 1954 Allis Chalmers WD-45. When I was 18, I dated a girl in the next county over. Her family are tobacco farmers. It was a cold Thanksgiving evening, and we were going up to her Grandparents house. As we passed one of their barns, I noticed something orange in the corner of my eye in this old shed. It was pretty dark and I asked what it was
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|