|
Farmall & IHC Tractors Discussion Board |
Re: Re: Any opinions on International 2+2 tractors?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on March 13, 2002 at 19:50:31 from (12.23.185.189):
In Reply to: Re: Any opinions on International 2+2 tractors? posted by the tractor vet on March 13, 2002 at 19:37:59:
I should have stated what we pull in my original post. We have a 26 foot chisel plow (12" spacing) with anhydrous spikes that our 2590 has its hands full pulling. For drills we have 28 feet of CaseIH 7200 hoe drills that our 1086 will pull, but not when it is wet. We are looking at the 6788 because we would eventually like to get a 25 or 33 foot air seeder and do everything in one pass. The 6788 has the same tranny as a 5488 correct? 3 ranges and 6 gears in each range right? These tractors have been well taken care of, always stored inside, and the 3388 has only 2000 or so hours. Steven
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
