|
Farmall & IHC Tractors Discussion Board |
Re: Any opinions on International 2+2 tractors?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on March 13, 2002 at 19:37:59 from (216.196.13.226):
In Reply to: Any opinions on International 2+2 tractors? posted by Steven@nd on March 13, 2002 at 18:56:01:
I am not a real expert on them but have worked on one and the thing to check is the center bushings and just like the rest of the IH's the same stuff. And if you are only going to planter and apply andhidrous the the 3388 should be enough unless ya got one huge planter or drill. You can tweek it to 150-175 and should not hurt it , my self i sorta like them and that one has the 4 speed trans i like that better then the 3 speed .
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Ford 600 Series - by Staff. The Ford 600 Series tractors bean production in 1954, and continued until 1957. Quite similar to the Ford NAA (Golden Jubilee) in design, it used the same 132 cubic inch Red Tiger engine with 31 horsepower. Several different models were made in the 600 Series, and these numbers were used to denote whether they used a particular transmission, hydraulic system, or PTO. The result was five different model numbers: 620, 630, 640, 650 and 660. These break down as follows:
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
