Tool Talk Discussion Board |
Re: Electric Motors...3450 vs. 1750 RPM
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jl Sargent on July 23, 2006 at 18:17:55 from (208.63.192.204):
In Reply to: Electric Motors...3450 vs. 1750 RPM posted by Glenn F. on July 22, 2006 at 20:05:05:
How the different speeds relate to your saw specifically I cannot say. How these two speeds relate to wear and tear and imbalance and motor life I know alot about. 1800rpm is the best, period. If all else equal then: Its affected by mass imbalance 1/2 as much as a 3600. Its bearings only turn 1/2 as much in a given amount of time. It has more iron in it, has better starting torque. Typically lasts longer than a 3600 because of above mentioned circumstances.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|