Posted by Brock-Ia on November 19, 2012 at 20:39:04 from (22.214.171.124):
In Reply to: 1655 vibration posted by counterclockwise on November 19, 2012 at 18:27:18:
If it never had the vibration before I would check a few things. Are or were any of the 4 engine mounting bolts run loose, and if so are the mounting pads worn down causing the misalignment? If so shim it up. Unhook the chain coupler and feel the transmission input shaft for play. If the tapered roller bearings are loose this will also cause a bad vibration.
I like the idea of the alignment bolt to tweak it perfectly, however I"m wondering if there is not a cause for the misalignment.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.