Posted by Ken Christopherson on March 24, 2014 at 11:09:00 from (184.97.220.222):
Hey all.
Was able to get some more work done on the A project. Got the flywheel off last night, the reduction cover, mains and crank out. Got one of the mains loose and the collar of the left (flywheel side) main bearing insert fell down into the crankcase. Pulled the other side out and saw that there was a spot in the bearing where it was starting to chip away. Guess I am doing mains, too.
The reduction gear was sloppy, so figured it was the outer bearing that went. Pulled the cover and found most of the bearing internals laying in the bottom. The gear itself has about 3/8" of movement in and out, and when turned, seems to want to spiral off of the shaft. I'm guessing that the splines on the gear are worn, due to driving with a bad bearing for (probably several) years. Looks like I'll probably be needing a reduction gear, as well as the outer bearing.
Third, the cam bearings are both shot. So I'll be needing those.
Fourth, the oil pump drive gear is missing two teeth. Be needing one of those too.
Seems like I make a leap forward, and take a few steps back with everything on this A. That's ok, though. At least I didn't give much for it. Just have to keep plugging away.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.