Farmall & IHC Tractors Discussion Board |
Two Way Valve
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by w6tractor on August 22, 2006 at 08:27:10 from (69.30.166.14):
Finally got around to installing at two way valve on my '53 Super M with live hydraulics. It works great! Possible problem is that the pump and all hoses get too hot to touch after running for a short time. I checked the valve and fluid runs through it back to the reservoir while the valve is is the neutral position. I have the factory hydraulic rod locked fully back with the tab on the side of the reservoir. Supply is from a fitting in front of the fuel tank. Return is "tee'd" into the filler pipe. Do I have a problem, or is this normal? Thanks
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|