Allis-Chalmers Discussion Board |
Re: WD draft control settings for plow/MM plow conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim T on October 30, 2001 at 17:26:47 from (216.166.193.104):
In Reply to: WD draft control settings for plow/MM plow conversion posted by Plow Man on October 29, 2001 at 20:21:31:
PLOWMAN, if you are trying to build a plow for an AC you have WAY,WAY WAY too much time on your hands!!! Finding the right plow for a WD should not be that hard or expensive I wouldn't think. GOOD LUCK I don't remember all the hyd settings for the pump plates but to transport you need the lever all the way up on the quadrant. Been a long time since I ran one of them. Jim T
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|