Posted by rufus80 on September 06, 2012 at 11:19:51 from (22.214.171.124):
So I am the new owner of a 6080. Traded a red one in on it. A couple questions, what is the serial number break on the factory repair of the thrust bearing problem, second what is the proper procedure on the pto when not in use. Also wasn't there a break in the serial number where AC installed higher compression pistons for easier starting in cold weather? This tractor has the ether button and heater button. Also has a little over 5000 hours and never had a loader on it.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.