I am making some assumtions with the bridge thing, but around here 20 years ago that was an issue, but all the real old bridges have been replaced, and a lot of the little old 'private' bridges have been replaced with large culverts.
If it took a couple of 4ft diameter culverts 40ft long just to get to 1000 acre patch, I would have it done within a week.......
It isn't that much money either. I just put one in on one farm, to get to the back 200 acres easier. 4ft diameter culvert 48ft long, good used shape, cost $1400. Took about 12 machine hours between the dozer and hoe (which I have my own, but still isn't free to run) and about 10 hours additional labor for help to manhandle everything.
Now I have a 30ft wide drive across a fairly large creek that you could go across in road gear if you wanted with whatever wieght you are hauling...
I got a little over $3000 in the crossing.
Even if it takes 2- 4ft ers to make a decent crossing, cost might be a little over $5000.
Not that big a deal in my book to have safe access.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.