Posted by Ethan Chamberlain on October 10, 2010 at 15:34:04 from (64.89.219.217):
hello I recently tore down my stuck super wd9 and have been working on trying to break it loose. I finally did break it loose but the #1 piston is still very tight in the sleeve. So my plan of attack was to pull the sleeve completely out, press the piston out, take the ridge off, hone the sleeve out, make sure the rings werent stuck, and put it all back together. Since #2 was stuck as well, i pulled it out to do the same without a problem. I was hoping #1 would come out easily as well, but it did not. I got the sleeve about 4 inches out of the block and that is were it sits now. I can not get it to move eather way now. I have tried everything I know of to get this stubbern sleeve out, but yet it still will not move. Does anybody have any ideas for me to try? any help is appreitatied. thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.