Posted by Derrick Gross on July 20, 2010 at 20:16:14 from (205.149.144.70):
I have another fence question so I just thought I'd update this old post. Yes, a year later and still working on the fence. Several delays put things off last summer and early this year but we're back at it now. I have just about half the line posts in. We're auguring and tamping each post. I know pushing is faster but I don't have anything capable of the job.
All the corners are in and most braces as well. We used the big 12" posts on the main corners and 9" on other, short run corners. All H braces are 4" x 8'. All corners and braces are round treated. They are braced with cable and gripples. They look great and appear to be capable of holding back a freight train. I don't think they'll be pulling out or heaving.
Line posts are cedar 16' apart.
To my question. I have several spost where it is just to wet for posts and I can't go around. The shortest span I can get between the posts is just under 40' in these places. There is a small creek in the middle but for the most part it is just muck, saturated peat. I think, if I could, I would be able to push a 12' post out of sight.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
