I'm at work and the pics on the website I was thinking about are not opening on my computer. Again, just as Dave Sherburn described. If it's just a barn or workshop, do you really need to heat the whole floor? What is your idea/s for the building (how warm do you want it)?
Just an idea, but if I had a 24x36 shop, I'd prepare the whole thing ready for the reinforcing. Form, add 2 inches of gravel, reinforce, and pour it 4ft in from the walls leaving a route to where you'd put your boiler (leaves you 16x28 open).
Then, put down 2 inch thick foam and 1 inch foam border, reinforce, and fasten your water (heater) tubing keeping it >6 inches from the edge and a foot apart. No since heating under a work bench or toolbox. In my house (100+ years old) part of the floor (warmest part without heating) was hard packed something (harder than dirt but not quite concrete) 3-4 inches of sand for insulation, and hardwood floor over it. Depending on how cold it gets in your area and prices, sand may be an option for you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
