Posted by dave2 on February 06, 2010 at 14:55:11 from (139.139.35.70):
In Reply to: over fill on oil posted by jose bagge on February 06, 2010 at 14:07:54:
When I was a private a long time ago, my "boss" sent me to change the oil in a duece and a half on the line. I got it all drained, filters changed and oil back in except about a gallon when I ran out. Took the empty can back and was taking out another 5gal can when he came and told me I had a phone call and he'd finish. Told him I was done except topping off and said he just needed to finish filling. When I got back outside, he was standing there with this stupid look on his face and a puddle of oil under the truck. He topped off real good. Poured the oil in until it ran over the valve cover. We had a ball over that for a couple years until everyone that knew it had left.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
