Tractor Talk Discussion Board |
Re: Re: Has any one used water glass
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by IHank on February 09, 2001 at 19:09:02 from (207.177.47.133):
In Reply to: Re: Has any one used water glass posted by Burrhead on February 09, 2001 at 15:07:59:
Good post Dr. Burrhead! I vaguely remember the military doing the sodium silicate trick. Best bet is do a proper weld or braze repair and be done with it. But, a temporary fix trick is to bring the thing up to operating temperature and have the coolant circulating, then dump in a small bottle of ginger powder from the grocery store and keep it circulating. This is not for a pressurized cooling system... The ginger powder will seep into the crack and swell and form sort of a scab as it comes thru and dries on the outside. This trick was taught me by an old timer when I was a kid. A variation of it is also told in my Granddad's 1914 Model T Ford owner manual. If the crack is into the combustion chamber or you gotta have a pressurized cooling system forget it and head for a competent cast iron repair shop. "Put a can of ginger powder in it kid!" I still remember that advise given me about 45 years ago. It worked too. Good luck and hope you don't need it, IHank
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|