Tractor Talk Discussion Board |
Pulled Head no clue why zero compression in 1 Cylinder
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rick from Paso on October 22, 2000 at 23:09:02 from (207.114.212.17):
In my poor old Case 310B, the Piston looks good albeit a little melted looking on the top. There is oil in cylinder, oil in coolant. The valves look and seem to function okay. Pumped compressed air into head from spark plug hole, bad cylinder held pressure like the good cylinders (with the head off). The bad cylinder's piston cycled and developed good compresion like the good cylinders. I can only conclude a bad head gasket? Would a bad valve guide do this? Any clue? How to proceed from here? Thanks for your help. Regards, Rick from Paso.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|