Posted by mnbob on June 20, 2009 at 04:41:40 from (96.2.153.241):
Today
So with this forcast, no blooms on the Alfalfa, would you cut??
Today: Sunny, with a high near 82. West northwest wind between 6 and 10 mph.
Tonight: Partly cloudy, with a low around 58. North wind around 7 mph becoming east.
Sunday: Scattered showers and thunderstorms, mainly after 1pm. Mostly cloudy, with a high near 79. Southeast wind between 8 and 11 mph. Chance of precipitation is 30%. New rainfall amounts of less than a tenth of an inch, except higher amounts possible in thunderstorms.
Sunday Night: Scattered showers and thunderstorms, mainly before 2am. Mostly cloudy, with a low around 60. South southeast wind between 8 and 11 mph. Chance of precipitation is 50%. New rainfall amounts of less than a tenth of an inch, except higher amounts possible in thunderstorms.
Monday: Isolated showers and thunderstorms. Partly cloudy, with a high near 84. South southeast wind between 8 and 11 mph. Chance of precipitation is 20%.
Monday Night: Isolated showers and thunderstorms. Partly cloudy, with a low around 61. Chance of precipitation is 20%.
Tuesday: Isolated showers and thunderstorms. Partly cloudy, with a high near 84. Chance of precipitation is 20%.
Tuesday Night: Scattered showers and thunderstorms. Mostly cloudy, with a low around 61.
Wednesday: Isolated showers and thunderstorms. Partly cloudy, with a high near 81.
Wednesday Night: Scattered showers and thunderstorms. Partly cloudy, with a low around 59.
Thursday: Isolated showers and thunderstorms. Partly cloudy, with a high near 80.
Thursday Night: Isolated showers and thunderstorms. Partly cloudy, with a low around 56.
Friday: Scattered showers and thunderstorms. Partly cloudy, with a high near 78.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.