Posted by Errin OH on June 20, 2009 at 05:23:20 from (71.79.146.236):
In Reply to: cut or not?? posted by mnbob on June 20, 2009 at 04:41:40:
That depends....
Do you want to be baling mold or hay?
I wouldn't even consider it. Mature hay is better than no hay with all the expense.
FWIW - I have and do hay cut right before rain as long as it is only a days worth. Trick is it must not be down more than a half day or so. A few years ago 4 days of good weather was few and far between. I would cut right up to a down pour (kept cutting if only a light rain. Then when the skies cleared (usally the next 3 days) I would get it baled up in time. Some, but not really any damage. Limited to the top layer. Tedded after the rains left. Serious damage comes when it has has a day or more of drying and/or extended rain (several days worth) after cut.
BTW - If you don't cut it "will not" rain for a week. If you do it "will" rain for a week. ?????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.