|
Tractor Talk Discussion Board |
The stupid question of the day PLEASE HELP!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Karl Bader on July 21, 2000 at 05:41:43 from (209.92.35.65):
I recently bought an old wagon gear for $50 locally and well the wood on top is shot. Now this is a low budget project because it will be donated to the Northampton County 4-H center for use to haul horse jumps around among other things. Now my question is (I will try to explain this) When I rebuild the wooden deck to it, it comes in layers, the 1st layer is 2 4x6s, followed by a second layer of beams going the opposite way (4x4) and then finally a decking of 1x6s on top of that. To save money would it work to build it this way instead, the bottom layer is 4x6s and then a top layer of 2x6s going the opposite way. Would this be strong enough or no? Any answer would be greatly apreciated. Thanks, Karl
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
