|
Tractor Talk Discussion Board |
Re: Re: fan bearing on Deere model MC
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Fleischer on July 02, 2000 at 12:45:23 from (38.32.11.238):
In Reply to: Re: fan bearing on Deere model MC posted by RonMC on July 01, 2000 at 10:10:17:
Thanks -- the only documentation I have is the attached image from the parts manual, printed out for me by the local Deere dealer, and it matches my tractor. It appears to match your description, too, except that there is no evidence of oil in the shattered parts, but running out of lubrication could be the reason for the failure! There is however at least a tablespoon or two of graphite powder around all the parts. Could the missing oil have been an oil/graphite mix, and the graphite be all that remains? While I have replacements for the spindle and bearing (and gaskets), I still have just the original "hub" (#14 on the parts page image, with the pulleys), showing a lot of wear in the rear opening. Plus there is this mysterious sheet-metal cone, not shown in this diagram possibly simply because it is interior, which I am beginning to assume was originally a part of the hub assembly, but which broke loose from the damage. It seems pretty clear to me now that I need to replace the hub assembly as well. In its current condition, the interior of the hub and hence the bearing is in no way sealed (either to keep lubricant in or dirt/water out). I wish I had a decent picture of it. (Well, I wish I had full replacement instructions, too!)
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
