|
Tractor Talk Discussion Board |
Re: Re: Question about cutting saplings with brush hog.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big fred on June 12, 2000 at 07:06:13 from (12.13.226.11):
In Reply to: Re: Question about cutting saplings with brush hog. posted by Paul Fox on June 12, 2000 at 03:40:59:
Paul, I was wondering whether it would make sense to leave the blades dull, in order to shatter the stumps instead of sharpening them and leaving a clean cut. My theory is that a shattered stump is less likely to puncture a tire or send up new growth, but a dull blade is going to take more power, which translates to working slower. I have the same problem, lots of 1-3 inch alder, vine maple and etc to cut on 2-3 acres.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
