Posted by rick165 on February 13, 2009 at 14:55:41 from (66.82.162.19):
i bought a new motor/hydraulic pump for my kawasaki mule that dumps the bed.it is 12 volts the motor sets on top the pump it is all one unit about the size of a football.any way i wire it up to the toggle switch .the up position on the toggle switch is supposed to raise the bed and down lowers it.pretty simple operation.the motors wire leads are about a foot long where they connect the wires from the switch this is where i put my volt meter at i have 12 volts going to and threw the motor and back the other wire.so this tells me 12 volts is going to and in threw the motor and back out but the motor does nothing not even a hum.ar first i thought maybe it wasnt getting a good ground so i connected a jumper wire from one of the 2 mounting bolts directly to the negative side of the battery and still nothing.am i doing something wrong or did i just get a bumm motor. thanks RICK
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
