Posted by PJH on December 19, 2008 at 18:43:45 from (71.171.243.85):
In Reply to: The Metric System posted by John B. on December 19, 2008 at 17:45:15:
The State of Illinois switched to metric measurements on their road construction plans a few years ago. (Some politician probably got rich somehow from it)
Us old guys had a devil of a time with the new measurements, but we learned it and did OK with only a few expensive goofs.
Then they switched back to "english" measure. (Some politician probably got rich somehow from it)
I like the "english" better, partly because it's easier to communicate with the labor force.
By the way, we had several new metric measuring tapes that had an extra meter in them. I think around 38 meters, there were two 38's. That cost me an extra day's work re-doing a few kilometers of stationing.
Also, why are there still 360 degrees in a circle on the metric system? Looks like there'd be 100 degrees. And 60 minutes in a degree? And 60 seconds in a minute? Why not 100? 24 hours in a day? I'm gettin' a headache. . .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
