I've got several of each in 30-30 and a few old 32 Special caliber. Marlin lever-actions have smoother actions, that's all. Both guns are reliable and there's no difference in accuracy between the brands that I've ever noticed. Work the lever on either one and see which one you like better. In my opinion, there is no contest. Marlin is smoother, and usually easier to put a scope on if you care about that. I've got several 39As in 22 rimfire, and they are my absolute favorite 22s.
With Marlin 30-30s, I've got on Model 1936, a few Model 36s, and a few Model 336s. All have been flawless but the rifling differs a little. "Microgroove" barrels saw a few changes over time.
I also have the special set "Brace of 1000" that was limited edition pair of lever-actions - a 30-30 and a 22 with octagon barrels and engraving. They were beautiful guns, but I bought cheap after they'd been in a house that burnt down. I suspect the metal has suffered from the special "heat treatment."
I've only got two Winchester lever-actions in 30-30, both 94s. They shoot just as well as the Marlins, but the actions have always looked sloppy and overly complicated to me - as compared to the Marlins. On the other hand, I have three pre-64 Model 70 bolt-actions, and love them.
When I lived in northern Vermont in the 70s, I got a Winchester Model 1894 Trappers Carbine with a 14" barrel. I traded my 64 Chevy truck for it - from a Canuck in Labelle Province. I later sold it for $400 and thought I'd made a killing (the truck only cost me $150). I wish I still had the gun, although the short barrel causes some legal problems.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
