Posted by RayP(MI) on June 09, 2008 at 06:19:24 from (207.241.137.116):
In Reply to: OT Alpacas posted by Devin Sparks on June 09, 2008 at 04:54:02:
We have sheep and llamas. Fenced in by woven wire stock fence. 4' high, closer mesh on the bottom. Wooden posts every 30', and two "T" posts in between, which means a post every ten feet. "T" posts are 7 1/2 feet, sunk about 3' deep. Posts have not been the problem. Sheep will rub up against fence until they have it stretched beyond belief. Llamas will reach through the fence to try to graze every blade of grass they can reach. Again fences are stretched beyond belief. How those llamas get their heads thru the fence is beyond me! Be sure your corner posts are very well secured and braced.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.