Posted by Dan O. on February 09, 2008 at 19:43:00 from (71.186.54.158):
I'm having trouble timing my 354 perkins injection pump. Had an 1850 with a tied up motor, purchased a 354 out of a 510 massey combine. Used oliver book to time pump after motor installed, will not start. looked at pump and the snap ring is in a different location than the old one was. Don't have a book for a 510. Oliver say to bring 28 degrees static and time with "F" on pump to edge of snap ring. This is not working. Can anyone tell me how to set the pump timing from Massey's version? Thanks. P.S. Don't try an engine swap of this kind. I ignored all infromation on this site about what a pain it can be-and every step of this has been a pain. It can be done, but patience and a lot of spare time to spend on this is necessary.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
