Posted by Dick L on December 13, 2007 at 09:30:11 from (72.11.21.66):
In Reply to: Re: Save the world???? posted by Mike (WA) on December 13, 2007 at 08:56:32:
When you get done extracting the ethanol from corn you still have corn to feed. Some have set up to feed it in the wet stage. It does take more energy to dry it for bagging to ship much of a distance. I keep hearing that the corn should be going for feed rather than fuel. Corn looses very little feed value in the extracting fuel.
Corn distillers dried grains/solubles (DDGS) are recovered in the distillery and contain all the nutrients from the incoming corn minus the starch. Thus, the DDGS has at least threefold the nutrients as the incoming grain. Since the stillage is recycled, the ratio of these more valuable amino acid types continues to increase so that eventually they represent approximately 16% of the final DDGS's amino acid content. No other feed ingredient results from such a great percentage of microbial products and their back stocking. DDGS typically analyzes at 27% protein, 11% fat and 9% fiber.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Oil, Oil Filter and Air Breather - by Curtis Von Fange. In the preceding articles we discussed some of the various aspects of doing a comprehensive tune up. Hopefully some light was shed on why we do or don't do certain things pertaining to inspections and order of events when doing a tune up. Perhaps some useful reasons were given for why parts fail and what to do about preventing part failure in the future. All these tips will help us think and reason out a problem in order to make our tune up last and, hopefully, keep us from spending extra mone
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
