Re: Welding Help??

Posted by Gene Dotson on April 17, 2007 at 17:26:25 from (69.88.222.62):

In Reply to: Welding Help?? posted by Allan In NE on April 17, 2007 at 17:05:02:

Allan;

I do most of my welding with a 6011 rod. It is a deep burn and fast freeze. It is good for dirty steel and torerates rust well. Has little slag to clean and next pass can burn out slag. It is a good "position" rod and will make a decent 1 pass vertical weld.

6013 is a slow freeze, shallow penetrating rod. Makes pretty welds if used flat.

I am assuming you are using AC current? If you are using DC current than use 6010 rod... Gene

Replies:

• Re: Welding Help?? Allan In NE 17:35:16 04/17/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]